Lab Equipments:
| S.No | ITEM | Description | TOTAL |
| 1 | Dual trace Oscilloscope | The Dual Trace Oscilloscope is a Solid state portable instrument design to operate in wide range of environmental conditions and provides the necessary performance for Accurate high frequency measures. | 8 |
| 2. | Function generators | Microcontroller based Function generator 5-digit frequency counter for INT/EXT (EXT up to 3MHZ counters)Sine/square/Triangle Amplitude :2mV-20Vpp | 10 |
| 3. | Flip-flops | Built in fixed power supply of +5V.JK flip flops, RS flip fops each four individually Clock Output with 1Hz and 10Hz frequency with switch selectable.Pulsar output, decoder using 7447 provided.
Low and high points using SPDT switches are provided as inputs LED’s are provided as outputs. |
5 |
| 4. | Dc Regulator power supply | - | 6 |
| 5. | LCR Resonance circuit | One micro ammeter fixed in board(250µA)Different Values of Resisteres,capacitors and inductors are given to observe different outputs | 6 |
| 6. | Junction diode characteristics | Variable DC regulated power supply of 0-15V @250mA.On board sill ion and germanium diodes.Dual range DC Voltmeter of 1.5V/15V
Dual range DC ammeter of 250µA/25mA. One 10K ohms potentiometer is provided for lad variation. |
6 |
| 7. | Super position &maximum power transfer theorem | Built in fixed power supply of +5VBuilt in Variable power Supply of 0-12V Super Position and maximum power transfer circuits are in one board. | 6 |
| 8. | Colpitt’s oscillator | Built in fixed power supply of +12VDifferent values of capacitors are provided to vary the output frequency. | 4 |
| 9. | RC&RL Circuits | 10K potentiometer provided on board.RC and RL low and high pass filters and series RLC circuit are provided in one board. | 5 |
| 10. | Transistor(BJT) characteristics | Two variables DC regulated power supplies of 0-15V @250mA.One NPN and one PNP transistor on boardDual range DC voltmeter of 1.5V/15V
DC milli ammeter of 0-10mA. DC micro ammeter of 0-150µA. |
10 |
| 11. | FET Characteristics | Two variable DC regulated power supplies of 0-5V,0-15V @250mA.Two different values of resistors on board.Dual range DC voltmeter of 1.5V/15V.
DC ammeter of 0-10mA. |
6 |
| 12. | Maxwell’s Bridge | - | 2 |
| 13. | Two stage RC Coupled Amplifier | Built in fixed Power supply +12V.Different Values of capacitors are provided on board to change the bypass values. | 4 |
| 14. | .UJT as a relaxation oscillator | Built in variable power supply of 0-12V.Different values of resistors and Capacitors to vary the output frequency.
|
4 |
| 15. | Thevenin’s & Norton’s Theorem | Built in variable power supply of 0-12VThevenin’s & Norton’s theorems ad equivalent circuits are provided on one board | 6 |
| 16. | Stepper Motor | - | 7 |
| 17. | Digital logic trainer Board | One bread boardFixed DC source 5V @ 0.5A8logical level input switches
Fixed DC source +/- 15V @0.5V 8 logic level indicators logic pulsar and clock generator with l/H variation One seven segment display with decoder potentiometers 10kΩ 47KΩ |
4 |
| 18. | Rectifiers &Filters | Built in AC power supply of 9-0-9V @250mA.Half,Full Wave,Bridge rectifiers are provided on board with L and C filters.10K Potentiometer is provided for load variation. | 10 |
| 19. | Schering Bridge | Built in AF Oscillator with 1KHZ frequency.Built in speaker and detector outputsDifferent values of capacitors to observe different outputs. | 2 |
| 20. | RC Phase shift Oscillator | Built in fixed Power supply +12VDifferent values of capacitors are provided on board to vary the output freq. Each element of RC network shifts the phase by 600 | 6 |
| 21. | Decade Counter and Binary Counter trainer | - | 3 |
| 22. | Multiplexer and d-multiplexer | - | 3 |
| 23. | Zener diode characteristics | Variable DC regulated power supply of 0-15V.Different values of three Zener diodes on board.Different values of three Resistors on board.
Dual range DC Voltmeters of 1.5V/15V Dual range DC ammeter of 250 A/25mA. One 10K ohms potentiometer is provided for load variation. |
3 |
| 24. | Operational amplifier trainers | Built in fixed Power supplies of 1V,2V,3V,+15V,-15VVariable regulated power supply of 0-5VFour Op-Amps Provided on board by using LM 324 IC, and single Op-Amp using 741 IC.
Different values of capacitors and resistors, Diodes to construct different circuits provided on board. One 10K ohms potentiometer is provided on board.
|
7 |
| 25. | 7447-7-segment decade driver trainer | - | 3 |
| 26. | Thermistor Characteristics | - | 4 |
| 27. | Astable Multivibrator using 555Ic | Built in fixed Power supply +12V @250mA.Different values of resistors and capacitors given to vary the output waveform.One external 555 configuration with IC is given on board. | 4 |
| 28. | Monostable multivibrator using555 IC | Built in fixed Power supply +12VDifferent values of resistors, capacitors and one 10K ohms potentiometer provided to vary the output frequency. | 3 |
| 29. | UJT Characteristics with two Meters | Two Variable DC regulated power supplies of 0-12V @250mA.Two values of resisters on board.Dc voltmeter 0f 0-15V
DC ammeter of 0-10 mA. |
4 |
| 30. | Adder & Subtract or kit | Built in fixed Power supply of +5V.Using AND,OR,NOR,EX-OR,NOT gates each four,2four-inpt AND gates provided in one board Low and high points using SPDDT switches are provided as inputs.LED’s are provided as outputs.
Verification of DeMorgan’s theorems using gates. |
4 |
| 31. | 3-pin Regulator IC-Kit | Built in AC Supplies of 18-9-09-18V @500mA.7805,790,7812,7912,7815,7915 fixed voltage regulations and LM317T adjustable voltage regulator,
Potentiometer, Different Values if resistors, capacitors and diodes are provided on board. |
5 |
| 32. | Wein Bridge Oscillator using Op-amp | Built in fixed power supply of +15V,-15V.Additional Op-Amp is provided for external use.Different values of resistors, capacitors and one 10K ohms
Potentiometers provide to vary different output frequencies. |
5 |
| 33. | Amplitude Modulation & de-Modulation | It has three parts namely carrier generator.AM modulator And AM demodulator. Built in fixed power supplies of +12V,-12V @250mA Carrier generator using 8038 IC with fixed frequency 100KHz and fixed amplitude. | 4 |
| 34. | Linear and Digital IC trainer | 5 | |
| 35. | Diode Detector characteristics | Built in fixed power supplies of +12V,-12VAF generator with variable frequency and variable amplitude. RF generator with variable frequency and variable amplitude Built in AM modulator. | 6 |
| 36. | 8085µp Trainer kits | CPU @3.072MHz with Maximum Memory Of 64KB(32Kb EPROM and 32 KB RAM) system us supplied with 16KB EPROM and 8KB RAM,48I/O Lines using tow No’s Of 8255.one RS 232 compatible interface using 8251,Three 16bit Timer/counter using 8253 | 9 |
| 37. | 8051µc Trainer kits | CPU @11.0592 MHz with Maximum memory of 128KB 64 KB EPROM and 64 KB Ram 48TTL I/O lines using 2 no of 8255’sThree 16 bit Timer using 8253 provision for File upload and file download Assembler & Dissembler through serial port. On BOARD LINE ASEMBLER AND DISASEMBLER Display 16 x2 Lines External ASCLL key boards with Built in Help menu. | 7 |
| 38. | 8051 Development Boards | Features of Phillips P89V51RD2On-chip 64KB flash program/Data memory.On-chip 1024bytes Data RAM.
On board Regulated power supply Input power supply 12v AC or DC On 40pin ZIF socket is provided on board for programming the controller on the board On-chip three 16-bit programmable counter array Operation at frequency 11.0592 MHz |
2 |
| 39 | Computer systems | - | 6 |
| 40 | Printer | - | 1 |
| 41 | LCD Projector | - | 1 |
| 42 | 8086µp trainer kit | - | 5 |
DEPARTMENT OF ELECTRONICS
| S.NO | ITEMS | Total |
| 1 | 8051 Keyboards | 8 |
| 2. | 8085 Keyboards | 9 |
| 3. | Decade Resistance Box | 8 |
| 4. | Decade Inductance Box | 3 |
| 5. | Decade capacitance Box | 2 |
| 6. | Stepper Motor interfacing cards | 4 |
| 7. | Rs 232 Cables | 7 |
| 8. | Dualdac Interfacing cards | 3 |
| 9. | 8-bit ADC Interfacing cards | 2 |
| 10. | 26-pin FRC Cables | 12 |
| 11. | Power supply for motor | 4 |
| 12. | Software CD for 8051 | 1 |
| 13. | Multileters (small) | 21 |
| 14. | Multimeters(Big) | 11 |
| 15. | 0-200mv Dc | 3 |
| 16. | 0-20mv Dc | 2 |
| 17. | 0-200ma Dc | 13 |
| 18. | 0-2-ma Dc | 7 |
| 19. | 0-200µaDc | 8 |
| 20. | 0-20v Dc | 6 |
| 21. | 0-200v Dc | 4 |
| 22. | Bread boards | 19 |
| 23. | Screw-driver set | 2 |
| 24. | CRO Probes | 22 |
| 25. | H1 Vat Battery(9v) | 63 |
| 26. | Soldering Iron | 6 |
| 27. | Iron stand | 6 |
| 28. | Cutting Players | 7 |
| 29. | Single stand wire bundle | 47 |
| 30. | Connecting wires bundle | 47 |
| 31. | Analog multimeters | 2 |
| 32. | Strippers | 3 |
| 33. | 8-bit ADC & DAC Interface card | 1 |
| 34. | Key board display | 1 |
| 35. | Speakers | 1 |
| 36. | Single side patch cards | 20 |
| 37. | Double side patch cards | 63 |
